IBM Books

Addendum to Nways Manager for Windows NT Installation Guide

SNMP and Service Pack 4

If these services are not already installed on your system, continue preparing your system by following the instructions to install them.

Installing SNMP Services

Reference to Checklist:This section corresponds to step 8.
Note

If SNMP services are already installed on your machine, then you should continue with "Installing Windows Service Pack 4".

To install SNMP Services, follow the following procedure:

  1. Select Start -> Settings -> Control Panels.

  2. Double click on the Network icon.

  3. Select the Services tab.

  4. Click Add.

  5. Select SNMP Service.

  6. Insert the Windows NT CD. Stop the process that automatically starts if autorun is enabled.

  7. Click OK.

  8. Type e:\i386\ in the edit field, where e is your CD drive.

  9. Click Continue.

  10. Enter any necessary information on the Agents, Traps, and Security tabs.

  11. Click OK.

  12. Click Close.

  13. Remove the CD from the drive.

  14. Click Yes to restart.

Note: If you just installed SNMP services on your system, then you must install or reinstall Windows Service Pack 4.

Installing Windows Service Pack 4

Reference to Checklist:This section also corresponds to step 8.

Service Pack 4 is available either on your Windows NT CD, or as an executable file available for download at: 


http://www.microsoft.com/support/winnt/default.htm

Once you have downloaded it, follow these steps to install it:

  1. Launch the Service Pack 4 executable file (example: filename.exe).

  2. Click the check box labeled Accept License Agreement.

  3. Click Install.

  4. Click Yes.

  5. Click Restart.

  6. Click Yes or No (appears after computer has restarted).

[ Top of Page | Previous Page | Next Page | Table of Contents ]